Table of Contents
Advertisement
2
Selecting a frequency-dependent offset table
You can select a frequency-dependent offset table by pressing
Freq. Dep. Offset
You need to enable the frequency-dependent offset table prior to configuring
NOTE
the measurement frequency value in the channel setup screen.
The Offset Tables screen is shown in
any frequency-dependent offset (FDO) tables are currently selected.
NOTE
You can also view which FDO table is being used by pressing
then use the up/down arrow key to highlight the FDO Table setting field and
press
Procedure
Use the following steps to select an offset table.
1 Press either:
–
–
60
.
to display the tables.
>
>
Tables
Freq. Dep. Offset
>
, then use the up/down arrow key to highlight the FDO Table
Offsets
setting field and press
Figure
2-12. The State column indicates if
.
to display the tables.
Keysight N432A User's Guide
>
>
Tables
>
,
Offsets
Advertisement
Table of Contents
