Table of Contents
Advertisement
2
2 Set the DMM to measure resistance. The resistance value obtained is the Ruser
If you have modified the resistance type and the Ruser value, the subsequent
power-up setting will correspond to the
Procedure
Use the following steps to set the resistance type.
1 Press
2 Use the up/down arrow key to highlight the Res Type value field, and press
Figure 2-3
3 When Ruser is selected, you can enter a resistance value within a ±10%
48
value.
to access the channel setup screen.
to display the Res Type pop-up list. Use the up/down arrow key to
highlight the desired bridge resistance type, and press
selection.
Resistance type pop-up list
tolerance level of the current bridge resistance setting. Use the left/right arrow
key to highlight the resistance value field, then press
Ruser pop-up. Use the numeric keypad to enter the required value and press
to confirm the entry.
Enter
Warm Start
state setting.
Keysight N432A User's Guide
to enter the
to display the
Advertisement
Table of Contents
