Table of Contents
Advertisement
3
Error list
Table 3-1
Error list
Invalid character
An invalid character was found in the command string. You may have inserted a character such as #, $,
– 101
or % in the command header or within a parameter.
Example: LIM:LOW O#
Syntax error
– 102
Invalid syntax was found in the command string
Example: LIM:CLE:AUTO, 1 or LIM:CLE: AUTO 1
Invalid separator
An invalid separator was found in the command string. You may have used a comma instead of a colon,
– 103
semicolon, or blank space; or you may have used a blank space instead of a comma.
Example: OUTP:ROSC,1
GET not allowed
– 105
A Group Execute Trigger (GET) is not allowed within a command string
Parameter not allowed
More parameters were received than expected for the command. You may have entered an extra
– 108
parameter, or added a parameter to a command that does not accept a parameter.
Example: CAL 10
Missing parameter
Fewer parameters were received than expected for the command. You may have omitted one or more
– 109
parameters that are required for this command.
Example: AVER:COUN:VOLT
Program mnemonic too long
– 112
A command header was received which contained more than the maximum 12 characters allowed
Example: SENSeAVERageCOUNtVOLTage AVC8
Undefined header
A command was received that is not valid for the N432A. You may have misspelled the command, it may
– 113
not be a valid command, or you may have selected the wrong interface. If you are using the short form of
the command, remember that it may contain up to four letters.
Example: TRIG:SOU IMM
Invalid character in number
– 121
An invalid character was found in the number specified for a parameter value
Example: SENS:BRES R100#H
118
Keysight N432A User's Guide
Advertisement
Table of Contents
