Installation Procedure In The Imageware Accounting Manager (Hereinafter Referred To Iwam) Environment; Installing The Hand Set; Points To Note At Installation; Checking The Contents - Canon iR C1020 Series Service Manual

Chapter 2
2.5.6 Installation Procedure in the imageWARE
Accounting Manager (hereinafter referred to iWAM)
Environment
1) Select "ON" in [Additional Func.] > [System Management Set.] > [Dept.
ID Management] and press [Set] key.
Check to see that "0000001 to 0001000" has been created in [Register
Dept. ID/Pass.]. (In the case that "1" is entered as the first number in the
following service mode item: COPIER > OPTION > ACC > CARD.)
2) Press 'Back' key or 'Done' key to exit [Additional Func.].
3) Make the setting for network in [Additional Func.] > [System Manage-
ment Set.] > [Network Settings] > [TCP/IP Settings] > [IPv4 Settings] >
[IP Address Settings].
MEMO:
Pressing [Network Settings] displays the following message. Press [Done]
key to exit the screen that displays this message.
[Changes become effective after the main power switch is turned OFF and
ON again.]
- In the case of [Manual Settings], make the setting of [IP Address]
[Subnet Mask] [Gateway Address] according to the environment of user.
- In the case of [Obtain Automatically], select either of the following;
[DHCP] [BOOTP] [RARP].
4) Press 'Back' key or 'Done' key to exit [Additional Func.].
5) Turn off and then on the main power switch.
6) Enter a number for [System Mgmt. Dept. ID] and [System Mgmt. Pass-
word] in [Additional Func.] > [System Management Set.] > [System
Manager Info. Set.], and then press [Register] key.
Note that 'Registration of card to the device' cannot be executed in setting
of iWAM unless [Additional Func.] > [System Management Set.] >
[System Manager Info. Set.] is selected and [System Mgmt. Dept. ID] and
[System Mgmt. Password] are registered.
7) Press 'Back' key or 'Done' key to exit [Additional Func.].

2.6 Installing the Hand Set

2.6.1 Points to Note At Installation

When installing this equipment, make sure that the FAX board is installed
first.

2.6.2 Checking the Contents

<Handset-J1>
[1]
[4]
[1] Handset
[2] Handset rest
[3] Handset adapter
[4] Plasti rivet
[5] Wire saddle
2-10
[2] [3]
[5]
F-2-25
1pc
1pc
1pc
4pc
3pc

2.6.3 Turning OFF the Power of the Host Machine

1) Turn OFF the main power.
2) Remove the power plug (for outlet).

2.6.4 Installation Procedure

0020-3780
1) Remove the 2 face seals [1]. (The removed face seals are not used.)
[1]
2) Install the handset adapter [1].
- 2 plasti rivets [2]
0020-1359
0020-0535
[2]
3) Install the handset rest [1].
- 2 plasti rivets [2]
[2]
4) Put the handset [1] on the handset rest.
F-2-26
[1]
F-2-27
[1]
F-2-28
0020-0538
0020-0539