Cleaning The Exterior Of The Drive - ABB ACH580-01 Hardware Manual

Note:
• Maintenance and component replacement intervals are based on the assumption
that the equipment is operated within the specified ratings and ambient conditions.
ABB recommends annual drive inspections to ensure the highest reliability and
optimum performance.
• Long term operation near the specified maximum ratings or ambient conditions may
require shorter maintenance intervals for certain components. Consult your local
ABB Service representative for additional maintenance recommendations.

Cleaning the exterior of the drive

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur. If you are not a qualified electrical
professional, do not do installation, commissioning or maintenance work.
1. Stop the drive and do the steps in section
before you start the work.
2. Clean the exterior of the drive. Use:
• vacuum cleaner with an antistatic hose and nozzle
• soft brush
• dry or damp (not wet) cleaning cloth. Moisten with clean water, or mild detergent
(pH 5-9 for metal, pH 5-7 for plastic).
WARNING!
Prevent water from entering the drive. Never use excessive amount of water,
a hose, steam, etc.
Electrical safety precautions (page 22)
Maintenance 215