Relay Cable; Control Panel To Drive Cable; Pc Tool Cable; Fpba-01 Profibus Dp Adapter Module Connectors - ABB ACH580-01 Hardware Manual

￭

Relay cable

The cable type with braided metallic shield (for example ÖLFLEX by LAPPKABEL,
Germany) has been tested and approved by ABB.
￭

Control panel to drive cable

Use EIA-485, Cat 5e (or better) cable with male RJ-45 connectors. The maximum length
of the cable is 100 m (328 ft).
￭

PC tool cable

Connect the Drive Composer PC tool to the drive through the USB port of the control
panel. Use a USB Type A (PC) - Type Mini-B (control panel) cable. The maximum length
of the cable is 3 m (9.8 ft).
￭

FPBA-01 PROFIBUS DP adapter module connectors

Frames R1...R3: The following connector types have been tested to fit in the tight space
for option slot 1.
• Phoenix Contact SUBCON-PLUS-PROFIB/PG/SC2, part number 2708245. Lead
the cable through the control cable hole on the right in the entry plate (1).
• Siemens, part number 6GK1 500 0EA02. Lead the cable through the middle control
cable hole in the entry plate (2).

Routing the cables

￭
General guidelines – IEC
• Route the motor cable away from other cables. Motor cables of several drives can
be run in parallel installed next to each other.
• Install the motor cable, input power cable and control cables on separate trays.
• Avoid long parallel runs of motor cables with other cables.
Guidelines for planning the electrical installation 103
1
2