External Control Connection Terminals, Frames R1 - ABB ACH580-01 Hardware Manual

￭
External control connection terminals, frames R1...R5
The layout of the external control connection terminals of the R1 frame is shown below.
Layout of the external control connection terminals is identical in frames R1...R5 but
the location of the control unit with the terminals is different in frames R3...R5.
R1...R5
X1
X2
X3
X4
X5
S4
S5
Operation principle and hardware description 45
X10
1
2
3
X13
X8
X7
X6
X14
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Programmable digital inputs
X4 Safe torque off connection
X5 Embedded fieldbus
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 Auxiliary fan connection (IP55)
X13 Option slot 1 (fieldbus adapter mod-
ules)
X14 Option slot 2 (I/O extension modules)
S4,S5
Termination switch (S4), bias resistor
switch (S5), see
(IEC) or Switches (page 190)
America)
1 Panel port (control panel connection)
2 Cold configuration connection. This
connector is used with the CCA-01
configuration adapter.
3
Power OK and Fault LEDs. See section
LEDs (page 227).
Switches (page 143)
(North