Step 6. Connect Center-Link - MacDon Harvest Header D65 Assembly Instructions Manual

STEP 6. CONNECT CENTER-
LINK
a. Proceed to appropriate section to connect the
center-link.
MECHANICAL LINK: M100, M105, M150, M155
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
1. Stop engine, and remove key.
C
2. Loosen nut (A), and rotate barrel (B) to adjust
length so that link lines up with header
bracket.
3. Install pin (C), and secure with cotter pin.
4. Adjust link to required length for proper
header angle by rotating barrel (B). Tighten
nut (A against barrel. A slight tap with a
hammer is sufficient.
CAUTION
Check to be sure all bystanders have cleared
the area.
5. Start engine and proceed to next page, step b.
169603
UNLOADING AND ASSEMBLY
A
B
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT: STANDARD FOR M200, M205; OPTIONAL FOR
M105, M150, M155
1. Stop engine, and remove key.
2. Relocate the pin at the frame linkage as
required to position the hook over the
header pin.
Check to be sure all bystanders have cleared
the area.
HEADER
TILT DOWN
3. Start engine, and activate HEADER TILT
switches on GSL to extend or retract center-
link cylinder, so that the hook lines-up with the
header attachment pin.
4. Stop engine.
5. Push down on rod end of link cylinder until
hook engages pin on header, and is locked.
6. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
7. Start engine, and proceed to next page,
step b.
20
CAUTION
HEADER TILT UP
(continued next page)
Revision B