Step 3. Remove Shipping Supports - MacDon Harvest Header D65 Assembly Instructions Manual

STEP 3. REMOVE SHIPPING
SUPPORTS
The removable supports are painted yellow.
Unless otherwise
supports, and all shipping material and
hardware.
a. Cut straps, and remove header boots from
shipping support. Set boots aside for later
installation.
b. Remove six bolts securing lower support to
header legs, and remove support.
c. Remove four bolts securing upper support to
header legs, and remove support.
169603
UNLOADING AND ASSEMBLY
NOTE
specified, discard
d. Remove two bolts on each center leg shipping
support, and remove stands.
e. If outer leg shipping supports are installed, remove
as follows:
1. Remove two bolts attaching stand to the leg
under the header.
2. Remove pin at top of stand, and remove
stand.
13
(continued next page)
Revision B