Draper Seal - MacDon Harvest Header D65 Assembly Instructions Manual

J. DRAPER SEAL
A
a. Check deck height so that draper (A) runs just
below cutterbar (B) with maximum 1/32 in.
(1 mm) gap, or with draper deflected down
slightly (up to 1/16 in. [1.5 mm]) to create a seal.
Measurement is at supports with header
in working position and decks slid fully
ahead.
b. Loosen tension on drapers. Refer to sub-step
F. DRAPER TENSION.
c. Lift draper up at front edge past cutterbar.
D
E
d. Loosen two locknuts (C) one-half-turn only on
deck support (D). There are two to four supports
per deck, depending on header size.
169603
PRE-DELIVERY INSPECTION
B
NOTE
C
e. Tap deck (E) to lower deck relative to supports to
achieve setting recommended above. Tap
support (D) using a punch to raise deck relative to
support.
f. Tighten deck support hardware (C).
g. Tension drapers. Refer to sub-step F. DRAPER
TENSION.
35
Revision B