MacDon Harvest Header D65 Assembly Instructions Manual page 34

d. If required, adjust outside reel arms as follows:
A
RH SHOWN - LH OPPOSITE
1. Loosen nut (A).
2. Turn cylinder rod (B) counter clockwise to
raise reel and increase clearance to
cutterbar, or clockwise to decrease.
3. Tighten nut (A).
4. Repeat at opposite side.
e. If applicable, adjust center arm as follows:
D
C
DOUBLE REEL - LOOKING UP
AT ARM UNDERSIDE
1. Loosen nut (C).
2. Turn nut (D) clockwise to raise reel and
increase clearance to cutterbar, or counter
clockwise to decrease.
3. Tighten bolt (C).
169603
PRE-DELIVERY INSPECTION
B
34
Revision B