Step 7. Connect Hydraulics - MacDon Harvest Header D65 Assembly Instructions Manual

STEP 7. CONNECT
HYDRAULICS
M150, M200 and M205 Windrowers may not be
factory equipped with D Series header and reel
hydraulics as shown below. If not, proceed to
step a. to install optional drive/lift kits. If already
equipped, go to step b.
HEADER DRIVE
REEL HYDRAULICS
Windrowers equipped
hydraulics have four header drive hoses
on the LH side, and up to five reel drive
hoses on the RH side.
169603
UNLOADING AND ASSEMBLY
NOTE
with D-Series
a. If required, configure the M Series windrower to
run a D-Series draper header by installing optional
drive/lift kits. See table below for appropriate kit(s).
Kits include
installation instructions, and should have been
provided with the windrower shipment.
TRACTOR
REEL
DRIVE/LIFT
M100 B5426
M105
M150 B5426
M155
B5426,
M200
B4651
M205 B5491
b. Connect header drive hydraulics (A), and electrical
harness (B) to header as follows:
1. Check connectors, and clean if required.
2. Disengage, and rotate lever (C) counter
clockwise to fully up position.
3. Remove cap securing electrical connector (B)
to frame.
4. Move hose bundle (A) from windrower around
hose support on header.
ELECTRICAL
RETURN
5. Push hose connectors onto mating receptacle
until collar on receptacle snaps into lock
position.
6. Remove cover on electrical receptacle.
22
all necessary hardware
OPTIONAL KITS FOR DRAPER HEADER
REEL FORE-
REVERSER
AFT
B5194 --
B5577 --
B5194
B5577
B4656
B5194
B5496 B5492
C
A
KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
DRAPER DRIVE
(continued next page)
and
COUPLER
--
--
--
--
--
B5497
B
Revision B