Reel Tine To Cutterbar Clearance - MacDon Harvest Header D65 Assembly Instructions Manual

I. REEL TINE TO CUTTERBAR
CLEARANCE
The finger to guard/cutterbar clearances with reel
fully lowered varies with header width, and are as
follows. See illustration opposite.
'X' +/- .12 in. (3 mm) @ REEL ENDS
HEADER
SINGLE REEL
15 FT
.78 in. (20mm)
20 FT
25 FT 1.00 in. (25 mm)
30 FT 1.77 in. (45 mm)
35 FT 2.36 in. (60 mm)
40 FT
---
45 FT
Y
X
169603
PRE-DELIVERY INSPECTION
DOUBLE REEL
---
0.78 in. (20 mm)
Z
33
CAUTION
Engage header lift cylinder stops before
working under header.
TAKE MEASUREMENTS 2 PLACES
6 INCH BLOCKS LEVEL GROUND
SINGLE REEL
TAKE MEASUREMENTS 4 PLACES
6 INCH BLOCKS
DOUBLE REEL
a. Raise header, and place a 6 in. (150 mm) block
under each inboard header leg.
b. Lower header onto blocks, and fully lower
the reel.
c. Adjust fore-aft reel position so that back end of
cam disc is approximately between 4 and 5 on
the arm decal.
LEVEL GROUND
(continued next page)
Revision B