MacDon Harvest Header D65 Assembly Instructions Manual page 16

Steps g. to m. apply only to Double Reel
headers.
DOUBLE REEL
g. Remove sling, and reposition around reel tube
near reel center support arm.
h. Lift reel to gain access to the center lift cylinder.
i. Remove shipping wire/banding from center reel lift
cylinder.
CENTER ARM - DOUBLE REEL ONLY
j. Remove socket head bolt and nut from cylinder
rod end.
k. Attach rod end of cylinder to reel arm with socket
head bolt and nut. Access hardware through holes
in reel arm braces
l. Remove pin at barrel end of cylinder.
m. Adjust reel height so pin can be installed at barrel
end of cylinder and mounting structure.
169603
UNLOADING AND ASSEMBLY
NOTE
n. Remove sling, and reposition around reel tube
near opposite outboard reel arm.
o. Remove shipping wire/banding from cylinder, and
remove pins from lug and arm.
p. Lift reel so that reel lift cylinder mounting holes line
up with lug on endsheet and hole in reel arm.
q. Secure cylinder to endsheet and reel arm with
pins as shown.
Cotter
Cotter pin inboard at endsheet.
16
NOTE
pin outboard at reel
(continued next page)
arm;
Revision B