Lubricate Header - MacDon Harvest Header D65 Assembly Instructions Manual

L. LUBRICATE HEADER
Refer to the illustrations that follow for lubrication
points.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
f. Use clean High Temperature Extreme Pressure
grease.
g. Master grease point location decals (shown
opposite) are provided on the header and adapter
back frames.
169603
PRE-DELIVERY INSPECTION
38
SINGLE KNIFE
DOUBLE KNIFE
ADAPTER
(continued next page)
Revision B