Step 6. Remove Shipping Stands - MacDon A30-S Assembly Instructions Manual

D
C
h. Remove lynch pin from pin (C) in header stand
at right side of header.
i. Hold stand (D) and remove pin (C).
C
j. Invert stand (D), and re-install on header leg in
upper hole location with pin (C). Secure pin with
lynch pin.
In soft conditions use a wooden block
under the stand.
k. Lower header onto stand (D).
Form 169078
UNLOADING AND ASSEMBLY
D
NOTE
STEP 6. REMOVE SHIPPING
STANDS
F
a. Remove two bolts (E) from shipping stand (F).
b. Remove hairpin from pin (G).
c. Hold shipping stand (F), remove pin (G), and
remove stand. Discard stand and hardware.
d. Repeat above steps for opposite shipping stand.
J
e. Remove four bolts (H), and remove angle (J).
Discard angle and hardware.
13
E
G
H
Revision C