Display And Menu Structure; Menu; Menu System; View Menu - Deif CGC 400 Operator's Manual

CGC 400 Operator's manual 4189340787
UK

3. Display and menu structure

3.1 Menu

3.1.1 Menu system

The display includes the menu systems listed below which can be used/viewed without password entry:
View menu system:
This is the commonly used menu system, which contains displaying of the measured values.
Log menu:
This menu contains event, alarm and battery logs.
Setup menu (not commonly used by the operator):
This menu is used for setting up the unit, and if the operator needs detailed information that is not
available in the view menu system.
Changing of parameter settings is password-protected.
Alarm list:
This list shows active acknowledged and unacknowledged alarms. Alarms can also be acknowl-
edged by pressing the OK button
Service menu:
This menu contains input-, output-, M-Logic status and data about the unit.

3.1.2 View menu

The view menus are the daily use menus for the operator. There are 20 configurable display views, with up to
three configurable display lines in each view. View configuration is done through the PC utility software
(USW).
In the view menus, various measured values are on the display.
AMF
G P
G Q
G S
Run absolute
DEIF A/S
First display line: Genset mode and running mode
MAN
Second display line: Measurements relating to operational status
0 kW
0 kVAr
Third display line: Measurements relating to operational status
0 kVA
Fourth display line: Measurements relating to operational status
0 hrs
Fifth display line: Running hours
Display and menu structure
Page 7 of 14