To Turn The Fire Off; Lighting With A Taper - Valor Black Beauty Slimline Installation And Owner's Manual

The burner settings are:
-
Control Knob
Position
1 / IGN
We recommend that the fire is set at position 4 for the first 10 minutes after lighting
-
to warm up the chimney and so obtain full efficiency quickly.
If operating the appliance for long periods it is beneficial occasionally to change the
-
settings. This will also help to remove any carbon deposits that may form during
operation.
Note: If the fire goes out while setting the control, repeat the full lighting procedure. If
the fire repeatedly goes out, have the fire serviced.

To turn the fire off.

Partially depress the control knob and turn clockwise to OFF. Release the knob.
-
Wait at least 3 minutes after turning the fire off before relighting.
-

Lighting with a taper.

In the unlikely event of failure of the ignition spark, the pilot can be lit with a taper or
long spill after the window surround has been removed. Removal of the surround is
described in the "Window Glass" chapter on the next page.
Light the pilot by inserting the taper or spill below
the centre of the window while the control is kept
depressed at the 1/IGN position (See figure 4).
When the pilot has lit follow the rest of the
instructions in the section headed "To light the
fire".
©
GDC Group Ltd. JAN 2017
OWNER GUIDE
Burner appearance
Centre section on low. Outer sections off.
2 Centre section fully on. Outer sections off.
3 Centre section fully on. Outer sections on low.
4 All sections fully on.
Figure 4.
Page 37