Settings; To Turn The Fire Off; Lighting With A Match Or Taper - Valor Brava 347 Installation And Owner's Manual

Radiant / convector gas fire
Table of Contents

Advertisement

Settings.

The control settings are shown in the table below:
Control Knob
Position
2
3
4
5

To turn the fire off.

Partially depress the knob and turn clockwise to off. Wait at least three minutes
before attempting to relight.

Lighting with a match or taper.

Electronic ignition: Depress the control knob
slightly and turn anticlockwise towards the
1/IGN position.
While keeping the knob depressed, light the
pilot by inserting a long match or taper into the
opening shown in figure 4 (Second opening
from the right).
When the pilot is alight, keep the knob
depressed for about ten seconds to allow the
flame sensing probe to warm up before setting
to your preferred heat level.
For your own convenience, have the heater
serviced as soon as possible.
©
GDC Group Ltd. OCT 2016
OWNER GUIDE
Radiants Condition
Centre radiants on low. Outer radiants off.
(The right hand centre radiant will glow slightly
more than than the left hand centre radiant due
to the pilot flame)
Centre radiants fully on. Outer radiants off.
Centre radiants fully on. Outer radiants on low.
All radiants fully on.
Page 38
Figure 4.

Advertisement

Table of Contents
loading

Table of Contents