Honeywell SYA14 Series Manual page 69

5.4.2 Using Soap and Water
1. Turn off and disconnect power to the light curtain and machine.
2. Dampen a soft, clean, non-abrasive cloth in the solution of mild soap and water.
Squeeze excess solution from the cloth.
3. Wipe the soiled areas gently with the damp cloth.
scratching the clear plastic front plate or paint finish.
4. Rinse the cloth in clean water and gently wipe off any excess soap.
5. Dry the emitter and receiver with a soft, dry, non-abrasive cloth. Ensure there is no
moisture left on the emitter and receiver units before power is applied.
6. Connect power to the machine and light curtain.
7. Perform the operational test to ensure proper functional readiness.
5.4.3 Cleaning the Mirrors
MIRROR DAMAGE
Use soft, clean, non-abrasive cloth to clean dust or dirt from mirror to prevent scratching
surface.
Failure to comply with these instructions may result in product damage.
1. Dampen a soft, clean, non-abrasive cloth with 90% alcohol or white spirit.
2. Wipe the face of the mirror gently with the damp cloth. Do not rub hard to prevent
scratching the finish.
3. Dry the mirror with a soft, dry, non-abrasive cloth. Ensure there is no moisture or lint
left on the mirrors.
4. Perform the operational test to ensure proper functional readiness.
107031-23 EN FR26 GLO 1199 Printed in France
Do not rub hard to prevent
69