Honeywell SYA14 Series Manual page 345

Introduction
Single Beam Device Installation and Use
The installation and use of a safety single beam device requires compliance with strict rules.
Correct installation is necessary to ensure safety and must be carried out by personnel
thoroughly familiar with all instructions and the following safety regulations.
Approvals
C
Standards Compliance
ANSI B11.19
ANSI/RIA R15.06
UL508
IEC1496 PART 1 and 2
EN 61496 PART 1 and 2
EN 292
EN 60204
pr EN 999
EN 294
pr EN 811
Regulations
OSHA 29 CFR 1910.212
vi Honeywell • MICRO SWITCH Sensing and Control
®
US
(applicable parts of)
Standard
FF-SPS4 Series Installation Manual
Only the packaging and the documentation
of FF-SPS4 Series products carry the CE
mark; the CE declaration of conformity is at
the back of this manual
Canadian Standards Association
Title
Safeguarding when Referenced by the
Other B11 Machine Tool Safety Standards
Safety Requirements for Industrial Robots
and Robot Systems
Underwriters Laboratory
International Electrotechnical Commission;
European Normalisation; Safety of
Machinery - Electrosensitive Protective
Equipment
Safety of Machinery - Basic Concepts,
General Principles for Design
Safety of Machinery - Electrical Equipment
of Machines
Safety of Machinery - Positioning of
Protective Equipment Related to Approach
Speeds of Parts of the Human Body
Safety of Machinery - Safety Distances to
Prevent Upper Limbs from Reaching
Danger Zones
Safety of Machinery - Safety Distances to
Prevent Lower Limbs from Reaching
Danger Zones
General Requirements for (guarding of) All
Machines
For application help: call 1-800-537-6945