Juniper EX9253 Hardware Manual page 54

Table 19: Port LED State and Color Rules
Pluggable Breakout
Inserted Configuration
State
No Any
Yes Breakout
Yes Breakout
Yes Breakout
Yes Breakout
The following factors trigger a change in the lane LED color:
• A breakout port is selected for a lane display.
• Port location mode is activated for a port on a given interface card.
Table 20 on page 45 describes the state and color rules for the lane LEDs.
Table 20: Lane LEDs Color Rules
Pluggable Breakout
Inserted Configuration State
Yes Breakout
(Continued)
Explicitly Port State
Disabled
No Anything except
disabled port;
however, transceiver
not present
No All breakout ports are
up
No All breakout ports are
down with LOS
No Hardware failure;
transceiver
initialization error at
the port level (not
individual lane)
Any In all other cases the
port LED color is
amber
Explicitly Port State
Disabled
No Up
Normal Port Lane
Location ON Display
Off Blinking –
green
Green Blinking Blinking
green green
Off Blinking Blinking
green green
Red Blinking red Blinking
red
Amber Blinking Blinking
amber amber
Order
1
45
LED Color
Green