• Selection of breakout port for lane display
NOTE: Ports with all individual links in
display, thereby reducing the time needed to cycle through all the ports.
Table 15 on page 38
describes the state and color rules for the port LEDs. These rules help in
determining the port LED color. When port location mode is activated, the port LED state or color can
be determined from the column titled
status display, then port LED state or color can be determined from the column titled
Table 15: Port LED State and Color Rules
Pluggable
Breakout
Inserted
Configuration
State
Yes
No breakout
Yes
No breakout
Yes
No breakout
Yes
No breakout
Any
No breakout
No
Any
Up state are skipped and are not considered for lane
Port Location ON . If the breakout port is selected for the lane
Explicitly
Port State
Disabled
No
Up
No
Down; loss of signal
(LOS) detected
No
Down; transceiver
hardware failure
No
Down; any other fault
other than LOS and
transceiver hardware
failure
Yes
Port is disabled by CLI
No
Anything except
disabled port;
however, transceiver
not present
Lane Display .
Normal
Port
Lane
Location ON
Display
Green
Blinking
–
green
Off
Blinking
–
green
Red
Blinking red
–
Amber
Blinking
–
amber
Amber
Blinking
–
amber
Off
Blinking
–
green
38