Mitsubishi Electric MELSEC iQ-R Series User Manual page 39

7.
Initializing the CPU module
Initialize the CPU module using the engineering tool. ( Page 43 Initializing the CPU Module)
8.
Setting parameters
The following table shows which parameters are required when changing the number of slots/the number of occupied points
of a module, using an SD memory card, or using specific functions.
When
Changing the number of slots or the number of
occupied points of a module
Using an SD memory card
Using the Ethernet function of the CPU module
Using an intelligent function module
System parameters are automatically set by loading an actual system configuration to the Module Configuration window of
the engineering tool.
9.
Programming
Create a program using the engineering tool. ( Page 46 Programming)
10.
Writing data to the programmable controller
Write the parameters set and the program created by using the engineering tool to the CPU module. ( Page 50 Writing
Data to the Programmable Controller)
11.
Resetting the CPU module
Restart the system in either of the following ways.
• Power off and on the system.
• Reset the CPU module. ( Page 51 Resetting the CPU Module)
12.
Checking for errors
Check the status of the READY LED and ERROR LED of the CPU module. If an error is detected, identify the error using the
engineering tool, and eliminate the error cause. ( Page 532 TROUBLESHOOTING PROCEDURE)
13.
Executing the program
Run the CPU module, and check that the PROGRAM RUN LED (P RUN LED) turns on. ( Page 52 Executing the
Program)
14.
Monitoring the program
Check that the program operates normally using the engineering tool. ( Page 53 Monitoring the Program)
Required parameter
• System parameters
• CPU parameters
• Memory card parameters
• Module parameters
Some intelligent function modules require multiple
module parameters and module extension
parameters.
Reference
Page 43 Setting Parameters
Page 225 BOOT OPERATION
Page 506 Label Access Setting from External
Device
 MELSEC iQ-R Ethernet/CC-Link IE User's
Manual (Startup)
 User's manual for the module used
4 START-UP PROCEDURE
4.1 Overview
4
37