Modify Vlan Port Settings - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide
5. Click Apply.
6. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
7. Click OK.
© Copyright 2020 TRENDnet. All Rights Reserved.

Modify VLAN port settings

VLAN > VLAN > Port Setting
After VLANs have been created, this section allows you to modify additional VLAN port
settings such as mode, port VLAN ID (PVID), acceptable frame type, and ingress filtering.
1. Log into your switch management page (see
on page 11).
2. Click on VLAN, click on VLAN, and click on Port Setting.
3. In the list, select the port or LAG and click Edit.
4. Review the settings below.
•
Mode – Select the VLAN port mode.
o
Access - This mode is used to connect edge devices that are VLAN
unaware such as workstations. The port can only be assigned
membership to a single VLAN as an untagged member port.
o
Trunk – This mode can allow traffic for multiple VLANs and is used to
connect to other VLAN aware network devices such as switches,
access points, and routers. This port can be assigned membership to
multiple VLANs as a tagged member port. The port can also be
assigned to a single VLAN as an untagged member also known as the
native VLAN.
o
Hybrid – This mode is similar to Trunk mode however, also allows for
control of ingress filtering and acceptable frame type.
•
PVID – This is port VLAN ID setting for the port and is used for untagged VLAN
member ports corresponding to the VLAN ID. When configuring VLAN port
membership under VLAN > VLAN Configuration, the PVID is automatically to
untagged VLAN member ports. You can also manually enter the PVID setting in
the field provided.
TPE-3012LS / TPE-3018LS
"Access your switch management page"
65