Configure Vlan Port Settings - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.

Configure VLAN Port Settings

Bridge > VLAN > Port Settings
In this section, you can modify the port VID settings, acceptable frame types, and
ingress filtering.
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on VLAN, and click on Port Settings.
3. Review the settings for each port. Click Apply to save settings.

PVID – Enter the port VLAN ID. Note: Required for untagged VLAN ports.

Acceptable Frame Type – Click the drop-down list and select which type of
frames can be accepted.
o
All – The port can accept all frame types.
o
Tagged – The port can accept tagged frames only. Untagged frames
are discarded.
o
Untagged – The port can accept untagged frames and frames with
tagged priority information only such as 802.1p.

Ingress Filtering –Click the drop-down list and select Enabled to enable ingress
filtering or Disabled to disable ingress filtering.
Note: Modifying settings in the row marked All, will apply the settings to all
ports.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
TEG-30102WS
"Access your switch management page"
47