Pd Alive Check - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide
4. Under the PoE Schedule Edit section, check the Schedule Status option to enable PoE
scheduling. Click the Name drop-down list to select the schedule you created and check
the PoE port or ports you would like to assign the schedule.
4. Click Apply.
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK.
© Copyright 2020 TRENDnet. All Rights Reserved.

PD Alive Check

PoE > PD Alive Check
This section allows you to configure a ping to a specific PoE device on a specific PoE port
and if the ping becomes unresponsive the switch will automatically disable and re-
enable the PoE port in an attempt to automatically recover the PoE device (PD powered
device).
1. Log into your switch management page (see
on page 11).
2. Click on PoE and click on PD Alive Check.
3. Check the PoE port with the PoE device connected to you would like to configure for
PD alive check and click Edit.
4. Check the Enable option for Status to enable PD alive check on the selected port.
Enter the IP Address for the PoE device under the ping PD IP Address (ex:
192.168.10.107)
Review the additional settings below.
•
Interval Time – Enter the time in seconds each time the switch will check for a
ping response from the PoE device. (Range: 10 – 300)
•
Retry Count – In the case that a ping response fails, enter the number of times
the switch will retry for a ping response before disabling and re-enabling the
PoE port. (Range: 1-5)
•
Action – An option must be selected for PD alive check to function.
o
None – If the ping response fails according to the time parameters set,
no action will be taken.
o
PD Reboot – If the ping response fails according to the time
parameters set, the switch will disable and re-enable the PoE port
attempting to automatically recover the connected PoE device.
TPE-3012LS / TPE-3018LS
"Access your switch management page"
61