Table of Contents
Advertisement
TRENDnet User's Guide
Upgrade ONVIF device firmware
ONVIF > Device FW Upgrade
After ONVIF compliant devices have been discovered and successfully authorized, you
can upgrade the firmware of the ONVIF device from the surveillance switch interface.
1. Log into your switch management page (see
on page 11).
2. Click on ONVIF and click on Device FW Upgrade.
3. Depending on your web browser at the top, for the Filename, click Browse or Choose
File and navigate to the folder on your computer where the unzipped firmware file for
the ONVIF device is located and select it. Then click Apply to upload the firmware file to
the surveillance switch.
4. After the firmware file has been successfully uploaded, a success message will appear
indicating that the firmware file was successfully uploaded. Click Done.
5. The firmware file name will now appear under Filename.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management
page"
6. In the IP Camera List, check the device you would like to upgrade with the previously
loaded firmware file, then click Upgrade.
Note: If you have multiple devices of the same model that use the same firmware file,
you can upgrade multiple devices of the same model by checking multiple devices in the
list before clicking Upgrade.
The Status will change to uploading indicating that the firmware of the ONVIF device is
upgrading.
If the firmware upgrade was successful, the Status will indicate that upgrade was
successful.
Note: After the ONVIF device has successfully upgraded firmware and reboots, you may
need to re-authorize the ONVIF device again under Discovery > IP Camera.
TPE-3012LS / TPE-3018LS
58
Advertisement
Table of Contents
