Add Static Multicast Group Addresses - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide

Add static multicast group addresses

Multicast > General > Group Address
Static multicast group addresses can be added to the table in addition to the multicast
group addresses that are learned by the switch dynamically.
1. Log into your switch management page (see
on page 11).
2. Click on Multicast, click on General, and click Group Address.
3. Click Add to add a new static muliticast address entry.
•
VLAN: Click the drop-down list to select the VLAN ID to assign the multicast
address.
•
IP Version – Select the IP address version of the multicast static address, IPv4
or IPv6.
•
Group Address – Enter the the multicast static address.
•
Member – In the Available Port list, select the ports to assign the multicast
static group address. You can use the arrow
remove to the Selected Port list.
•
Note: Multiple ports can be selected at the same time by holding the Shift or
Ctrl key.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management page"
buttons to add and
4. Click Apply.
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK.
TPE-3012LS / TPE-3018LS
91