Allocating Key Functions - Sokkia SRX1 Operator's Manual

21.6

Allocating Key Functions

It is possible to allocate the softkeys in Meas mode to suit the measurement conditions. It is possible
to operate the SRX efficiently because unique softkey allocations can be preset to suit various
applications and the ways that different operators handle the instrument.
• The current softkey allocations are retained until they are revised again, even when the power is cut
off.
• Press [CLEAR] in <Customize/Select screen> to return all customized configurations to their
previous settings.

• When softkey allocations are recorded and registered, the previously recorded key settings are
cleared.
● The following are the softkey allocations when the SRX was shipped.
(SHV and SHVdist tabs of <Basic measurement>)
Page 1 [AT On] [MOTOR] [0SET] [DIST]
Page 2 [SRCH] [EDM] [H.ANG] [COORD]
Page 3 [OFFSET] [RESEC] [REM] [S-O]
(Meas. tab of <Setting out>)
Page 1 [AT On] [/shvR] [H.ROTA] [DIST]
Page 2 [CNFG] [ --- ] [ --- ] [ --- ]
Page 3 [ --- ] [ --- ] [ --- ] [ --- ]
(SHV and NEZ tabs of <Set out Coords>)
Page 1 [ OK ] [ AT On ] [H.ROTA] [DIST]
Page 2 [ --- ] [ --- ] [ --- ] [ --- ]
Page 3 [ --- ] [ --- ] [ --- ] [ --- ]
● The following functions can be allocated to the softkeys.
[ --- ] : No functions set
[DIST] : Distance and angle measurement
[H.ROTA] : Rotate SRX to the entered horizontal angle
[CNFG] : Set motor drive operation functions (search accuracy, search offset, A.T. setting,
search method, search area)
[/SHV] : Switches Distance input mode between slope distance (S)/horizontal distance (H)/
height difference (V). The capitalized letter in the softkey indicates the currently
selected mode.)
[/SHVR] : Switches Distance input mode between slope distance (S)/horizontal distance (H)/
height difference (V)/REM (R). The capitalized letter in the softkey indicates the
currently selected mode.
[0SET] : Set horizontal angle to 0°
[H.ANG] : Set required horizontal angle
[R/L] : Select horizontal angle right/left. The capitalized letter in the softkey indicates the
currently selected mode.
21. CHANGING THE SETTINGS
129