Locking/Unlocking The Remote; Locking The Remote; Unlocking The Remote; Using Sleep Mode - Invacare LINX REM400 User Manual

LiNX® Control System
Give a short demand to left C to turn on/off the hazard
l
lights.
Give a long demand to left or right D to turn on the left or
l
right turn signal. Give a short demand to turn off the turn
signal.
Turn signals turn off after 10 seconds.
Activate a drive function card to drive normally while
position lights and hazard lights remain on.

6.13 Locking/Unlocking the Remote

The lock feature is not set to ON at the factory but can
be enabled by your provider. If this parameter is set to
ON, you can lock/unlock the system as described.

6.13.1 Locking the Remote

1. Press the ON/OFF button for more than three seconds,
until a locking overlay displays. The remote powers down.
When powering up the remote, the locking overlay
displays.

6.13.2 Unlocking the Remote

1. Press the ON/OFF button.
Tap the locked display until the white frame around the
locking screen Afills. The touch display is unlocked and
52
can be used again.
If you do not apply the unlock sequence or the ON/OFF
button is pressed again before the unlock sequence is
complete, the system returns to the locked state and
powers down.

6.14 Using Sleep Mode

Sleep mode is not set at the factory but can be enabled by your
provider. If this parameter is set to ON, the system goes into
sleep mode after a period of time without user activity. This
period can be set by the provider.
Before a system goes into sleep mode, the system enters a
transition period. During the transition period, the touch
display and all indicators slowly dim until they switch off.
During the transition, sleep mode can be interrupted by moving
the joystick, pressing the ON/OFF button or tapping on the
touch display.
To wake the system from sleep mode, press the ON/OFF button
or move the joystick, if this parameter has been enabled by the
provider.

6.15 Using Rest Mode

The rest state of the LiNX system provides the occupant with a
safe environment in which to sleep, rest or carry out other
activities without fear of accidentally triggering an unwanted
action with the driver control.
The rest state is entered automatically after a period of user
inactivity (timeout) or manually by the user via a control input,
as configured by the provider. Contact your provider for more
information.

6.15.1 Entering Rest

The system can be programmed to enter rest automatically
after a period of inactivity or manually via a control input or
both. Specifically, rest can be entered from:
A drive or seating function via timeout
l
Any function via a control input, such as an egg switch
l
60126081-C