Menu Screen Controls; Buttons - Invacare LINX REM400 User Manual

1.
Swipe-and-Tap Mode
Slide the set point E
up or down.
The proportion of the green sections A and yellow
sections B on the speedometer and the speed slider
correspond to the position of the set point E.
As soon as you start driving, the speed slider and Navigation
button disappear from the display. The current speed on the
speedometer, if it is enabled.
60126081-C
Tap Mode
Tap the top or bottom of the
speed slider D. Plus and minus
symbols indicate where to tap.
The speedometer/odometer display is a new feature
introduced for LiNX MR6.0. It replaces the sweeping
speed gauge that wrapped around the speed dial.
If both the firmware and the configuration are
l
greater than version 5.1.10, the new
speedometer/odometer displays when it is
enabled.
If both the firmware and the configuration file are
l
less than or equal to version 5.1.10, the previous
speed indicator displays.
If the firmware is greater than version 5.1.10 and
l
the configuration file is less than or equal to
version 5.1.10, no speed indicator displays.

6.1.5 Menu Screen Controls

Buttons

Buttons are used to perform an action, such as
screen.
Currently we use the following buttons on our remotes:
Symbol Action
Close the screen.
Return to the previous screen.
Open the next screen/level. Note this button
displays only if a next menu entry exists.
Increase or decrease the clock hour or minute
value.
6 Usage
to close the
23