Force Point Push For Digital/Analog Data; Table 22: Record Section (May Repeated Up To 8 Times) - Emerson PACSystems RX3i DNP3 User Manual

PACSystems™ RX3i DNP3 Outstation User Manual
GFK-3103B

Table 22: Record Section (may repeated up to 8 times)

Index
[003]
[004]
[005]
[006]
[007]
[008]
[009]
[010]
[011]
[012]
[013]
[014]
[015]
5.6.2

Force Point Push for Digital/Analog Data

All the points in a DNP3 Object can be forced to update their data only through Point Push feature.
When "Force DI Points to Point Push" parameter in DNP3 General Setting Tab is set to True, all the
Points in Obj01 will start in Point Push mode. However, it takes a single snap-shot of all the point values
at start up and will not mark the points with changed bit set in the flag. This feature can be used when
the Point Push interface is being used with the Soft SOE block application, to not to detect change of
data repeatedly for the same point.
Similarly, use Force DO Points to Point Push, Force AI Points to Point Push and Force AO Points to Point
Push for the respective DNP3 Objects.
1 [3], [16], [29], [42], [55], [68], [81], and [94] are the starting indices for each repeated record section, which may be repeated up to eight times. Each record
consists of thirteen words.
2 In the case of DI or DO objects, when Data[0] is non-zero, Point Push interprets the value as True
3 In the case of DI or DO objects in 32-bit mode, both Data[0] & Data[1] are used.
4 Seconds1k indicates the number of seconds denominated in milliseconds. Thus, 1 second has a value of 1000 milliseconds.
System Operation
Field
Object 01 – for DI, 10 – for DO
1
30 – for AI, 40 – for AO
Variance Typically, 0, inheriting the variance of the point setup
Point Point Number, 0 to the maximum possible point number by Object
Data[0] Low Word of Data
Data[1] High Word of Data
Unused Unused
Unused Unused
Hour Hours
Minute Minutes
Seconds1k 4 Seconds
Month Month
Day Day
Year Year
Description and values
2
3
Section 5
June 2020
61