Application Layer Parameters; Table 6: Application Layer Parameters - Emerson PACSystems RX3i DNP3 User Manual

PACSystems™ RX3i DNP3 Outstation User Manual
GFK-3103B
3.1.2

Application Layer Parameters

Table 6: Application Layer Parameters

Parameters
Validate
Source
Address
Source
Address 1
to 8
Transmit
Fragment
Size
(bytes)
Multi-
Fragment
Response
Multi-
Fragment
Confirm
Application
Confirm
Timeout
(mSec)
Unsolicited
Confirm
Timeout
(Sec)
DNP3 Configuration Parameters
Description
Application layer validates source
address in received frames.
If enabled, masters can establish the
connections with outstation using the
configured LLA Addresses.
If disabled, Master's LLA addresses is
not validated and can establish the
connections with Outstation.
Note: If Validate Source Address is
enabled then Validate Source IP gets
enabled by default, user needs to
configure the Source IP Addresses.
In HSB Configuration, this value is
always Enabled.
Refer Section 5.2.2.
List of Master LLA Addresses that a
given Master can establish a connection
with DNP3 Outstation on Channel[x].
Maximum value of Transmit Fragment
Size.
For e.g., if configured as 1024, then
Outstation will transmit messages with
Fragment size of 1024 bytes.
If set to True, DNP3 Application layer is
allowed to send Multi-Fragment
responses from Outstation to Master.
If set to False, DNP3 Outstation sends
the response data in Single Fragment of
configured "Transmit Fragment Size".
If set to True, Application layer
confirmations will be requested for
non-final fragments of a multi fragment
response.
Specifies how long the Outstation will
wait for an Application layer
confirmation from the DNP3 Master for
a Solicited Event response.
Specifies how long the DNP3
Outstation will wait for an Application
layer confirmation from the DNP3
Master for an Unsolicited Event
response.
Section 3
June 2020
Valid Values
Value: Enabled/Disabled
Default: Disabled for
Simplex, Enabled for HSB
Note: HSB configuration is
applicable only for
CPE400/CPL410
Value: Valid LLA (In Range
of 1 to 65519)
Default: 3, 5, 6 to 11, for
respective number of
Masters
Value: 1 to 2048 Bytes
(Modulus of 128)
Default: 2048 Bytes
Value: True/False
Default: True
For CPE115 when
configured using SVC_REQ:
Value: 1 / 0.
Value: True/False
Default: True
For CPE115 when
configured using SVC_REQ:
Value: 1 / 0.
Value: 1 to 65535 mSec
Default: 30 mSec
Value: 1 to 300 Sec
Default: 10 Sec
27