Strict Tcp/Ip Address Matching; Validate Source Ip; Table 17: Strict Tcp/Ip Address Matching - Emerson PACSystems RX3i DNP3 User Manual

PACSystems™ RX3i DNP3 Outstation User Manual
GFK-3103B
5.2.1

Strict TCP/IP Address Matching

Use parameter Validate Source IP to enable restrictive TCP/IP addressing features. Parameters IP
Address 1 through IP Address 8 are then used to set the IPV4 addresses of the master stations that are
allowed to connect to the Outstation. Reference the table below for address assignments. Set values
for these parameters as required by the application.

Table 17: Strict TCP/IP Address Matching

Parameter

Validate Source IP

IP Address 1
IP Address 2
IP Address 3
IP Address 4
IP Address 5
IP Address 6
IP Address 7
IP Address 8
System Operation
Description
Strict TCP/IP Address Matching for Master Stations:
Value: Enabled / Disabled
For CPE115 when configured using
Value:1/0
Valid IP address - Master Station 1
Valid IP address - Master Station 2
Valid IP address - Master Station 3
Valid IP address - Master Station 4
Valid IP address - Master Station 5
Valid IP address - Master Station 6
Valid IP address - Master Station 7
Valid IP address - Master Station 8
:
SVC_REQ
Section 5
June 2020
53