Dnp3 Object Attributes; General Parameters; Table 10: General Parameters - Emerson PACSystems RX3i DNP3 User Manual

PACSystems™ RX3i DNP3 Outstation User Manual
GFK-3103B
3.2

DNP3 Object Attributes

This section provides details to configure DNP3 Object Attributes:
■
■
■
■
■
■
3.2.1

General Parameters

This section describes DNP3 Outstation general parameters:

Table 10: General Parameters

Parameters
Digital Input
Analog Input
Counters
Digital Output
Status
Digital Output
/ CROB
Analog Output
Status
Analog Output
/ AOV
Event Modes
DNP3 Configuration Parameters
General Parameters
Point Template Configuration
DI Attributes
DO Attributes
AI Attributes
AO Attributes
Digital Input is defined as a DNP3 Object Binary Inputs – Obj01.
Corresponding PLC memory type, memory address, and number of
Points are required to be configured. Set the configuration parameter
values as required by the DNP3 application.
Analog Input is defined as a DNP3 Object Analog Inputs – Obj30.
Corresponding PLC memory type, memory address, and number of
Points are required to be configured. Set the configuration parameter
values as required by the DNP3 application.
Counters is defined as a DNP3 Objects such as Binary Counters - Obj20
and Frozen Counters – Obj21. The number of points is same as
configured for Binary Inputs – Obj01. Set the configuration parameter
values as required by the DNP3 application.
Digital Output Status is defined as a DNP3 Object Binary Output Status –
Obj10. Corresponding PLC memory type, memory address, and number
of Points are required to be configured. Set the configuration parameter
values as required by the DNP3 application.
Digital Output is defined as a DNP3 Object Control Relay Output Block
(CROB) - Obj12 . Corresponding PLC memory type, memory address, and
number of Points are required to be configured. Set the configuration
parameter values as required by the DNP3 application.
Analog Output Status is defined as a DNP3 Object Analog Output Status
– Obj40. Corresponding PLC memory type, memory address, and
number of Points are required to be configured. Set the configuration
parameter values as required by the DNP3 application.
Analog Output is defined as a DNP3 Object Analog Output Value (AOV) -
Obj41. Corresponding PLC memory type, memory address, and number
of Points are required to be configured. Set the configuration parameter
values as required by the DNP3 application.
DNP3 Outstation Objects support following Event Modes:
Description
Section 3
June 2020
33