Table of Contents
Advertisement
PACSystems™ RX3i DNP3 Outstation User Manual
GFK-3103B
5.8
Per-Point Configuration
,DNP3 Outstation supports point-level configuration, which allows users to configure different Event
Class Mask Type and Event Mode for individual points that overrides the default values set at the Object
level. Users can choose to configure per-point configuration either point basis or a range of points.
1. Object[xx] Per Point Configuration
2. Point Template configuration
For CPE115 when configured using SVC REQ, this feature is not supported.
5.8.1
Object[xx] Per Point Configuration
User can use "Number of Point Configurations Object[xx]" parameter to set per point configuration,
when this parameter is set to non-zero value it populates a new properties page tab which will allow us
to do per-point configuration. A maximum of 512 points is allowed for a given event Object.
Users can configure the following parameters on Per Point basis:
Point Index:
Index of the Point for which the non-default configuration is required. This can be configured with
values in Range of 0 to Number of Points for Object[xx] - 1. Index values need to be unique and cannot
be duplicated.
Event Mode:
Event Mode can be configured with below modes:
a) MOST RECENT
b) SOE (Sequence to Events)
Class Mask:
Event Class Mask Type can be configured with below types:
For e.g. - Per point Configuration - DI Attributes
In this example Number of Points for Object01 are configured to 10 with default Event Mode as MOST
RECENT and default Event Class Mask Type as CLASS MASK ONE. If user desire to configure 5 points
with different Event Class Mask Type and Event Mode, then the 'No. of Point Configurations Object02'
parameter needs to be set to 5 as shown below.
System Operation
a) CLASS MASK NONE
b) CLASS MASK ONE
c) CLASS MASK TWO
d) CLASS MASK THREE
Section 5
June 2020
64
Advertisement
Table of Contents
