Min Flow; Max Flow2; Min Flow2; Max Vs M/S - Siemens SITRANS FUG1010 IP65 NEMA 4X Instruction Manual

Section 4 1010GCNFM-3C
To enter the Max Flow range setting:
1. Press the <Right Arrow> to activate numeric entry.
2. Use the numeric keys to type the maximum flow rate (100% of range).
3. Press <ENT> to store the data.

Min Flow

The [Min Flow] menu cell stores the minimum range for the flow rate output (Vfo). It can be a positive or
negative value (to reflect bi-directional flow). However, the minimum span for the unsigned flow (Vfab)
is always zero. Enter the data using the flow rate units you selected.
To set the Min Flow range:
1. Press the <Right Arrow> to activate numeric entry.
2. Use the numeric keys to type the minimum flow rate (0% of range).
3. Press <ENT> to store data.
The following Span Data items are set in the same way as the previously shown examples by entering
numeric values and storing the data.

Max Flow2

The [Max Flow2] menu cell stores the maximum range for the flow rate output (Vfo). It can be a positive
or negative value. Enter the data using the flow rate units you selected.

Min Flow2

The [Min Flow2] menu cell stores the minimum range for the flow rate output (Vfo). It can be a positive
or negative value (to reflect bi-directional flow). Enter the data using the flow rate units you selected.

Max Vs m/s

The [Max Vs m/s] menu cell stores the maximum range for the sonic velocity output. The sonic velocity
(Vs) appears on the Stripchart display and can drive any analog output or the alarm relay. The [Max Vs
m/s] menu cell restricts this parameter to a maximum range of 1500 m/sec.

Min Vs m/s

The [Min Vs m/s] menu cell stores the minimum range value for the sonic velocity output. The sonic vel-
ocity (Vs) can be displayed on the Stripchart and drive any analog output or the alarm relay. The [Min Vs
m/s] menu cell restricts this parameter to a minimum range of 0 m/sec.

Max SG

The [Max SG] menu cell stores the maximum range value for the specific gravity output. The specific gra-
vity appears on the Stripchart display and can drive any analog output or alarm relay. The [Max SG] menu
cell restricts this parameter to a maximum range of 100.

Min SG

The [Min SG] menu cell stores the minimum range value for the specific gravity output. The specific gra-
vity can be displayed on the Stripchart and drive any analog output or alarm relay. The [Min SG] menu cell
restricts this parameter to a minimum range of 0.
4-43