Graphic Display Settings - Siemens SITRANS FUG1010 IP65 NEMA 4X Instruction Manual

Section 2
Plug input power connector (P10) into connector J10 and secure using two captive connector mounting
z
screws as indicated above.
Pull wires through flowmeter case cable hole.
z
Replace access cover.
z
Place power ON/OFF switch to the OFF position.
z
Connect the power cables to the appropriate power source (100-250 VAC @ 50/60 Hz or 9-36
z
VDC).
Place power ON/OFF switch to the ON position and power up unit. If unit is operational, turn power off
z
and install transducer cables.
2.3

GRAPHIC DISPLAY SETTINGS

Within 30 seconds of power-up the flowmeter main display will become active and a Siemens graphic
z
will appear. The screen also identifies the software version of the unit as shown below.
Press the <MENU> button and the Installation Menu will appear.
z
Proceed to Section 3 - Getting Started to become familier with the Installation Menu.
z
Siemens Dual Path
Create-Name-Recall-Enable & Delete Site
Channel/Path Setup
Pipe Data
Gas Parameters
Pick/Install Meter
Operation Adjust
Flow/Total Units
Data Span/Set/Cal
Stripchart Setup
Datalogger Setup
I/O Data Control
Diagnostic Data
Clamp-on Gas
2-2
ver. 3.01.00
SITE 1
7.900
1010GCNFM-3C
Software
Version
(x.xx.xx)