Program And Deliver A Clinician Activated Loading Dose - Abbott GEMSTAR Operating Manual

Clinician Instructions
Adding a Second Lock Level
d 1
Complete steps 1 and 2 for "Locking the Pump".
Note: When the pump is in a single lock state, the pump displays
SEQUENCE NUMBER
Pain Management, and the clinician wants to add
the pump will request the Lock Sequence Number before
added.
2
Enter the Lock Sequence Number.
d 3
Complete steps 4 and 5 for "Locking the Pump".
Note: When two lock levels are applied, if a function is available under one lock level but
not the other, the more stringent restrictions apply.
Unlocking the Pump
1
Select the locked level from the Keypad Lock Menu.
2
Enter the lock sequence number for that level.
d
Note: If the pump is locked under two levels, each level must be unlocked separately.
Unlocking one level has no effect on the other level. For example, if both
RATE CHANGE
and
CHANGE
3
The pump displays the current lock levels. Press [
the pump was in when the Options Menu was selected.

Program and Deliver a Clinician Activated Loading Dose

This feature is available only when the keypad is
only lock level. The loading dose rate is 125 mL/hr.
1
From the
STOP
2
PROGRAM A LOADING DOSE?
3
Press [
YES/ENTER
4
Enter the loading dose. Press [
d 5
DELIVER THE LOADING DOSE NOW?
Note: If [
YES/ENTER
clinician activated loading dose is complete. Press [
loading dose is complete.
86
. For example, if the pump is currently under
lock levels are applied, the clinician must unlock both the
locks.
THERAPY
mode, press [
YES/ENTER
displays.
] to continue.
YES/ENTER
displays.
] is pressed, infusion DOES NOT begin automatically when the
Abbott GemStar Manual 430-600095-002 (Rev. 8/02)
ENTER LOCK
THERAPY LOCK
as a second lock level,
RATE CHANGE
RATE CHANGE
THERAPY
] to return to the mode
YES/ENTER
or when
UNLOCKED THERAPY
] immediately followed by [
] when done.
] to resume infusion after the
START
for
lock can be
and
RATE
is the
].
0