Abbott GEMSTAR Operating Manual page 57

Intermittent
9
SET CALL BACK ALARM FOR NEXT DOSE?
The pump may be disconnected from the patient between dose deliveries. The call
back alarm can be set to alert the patient or caregiver to reconnect the pump before
the next scheduled delivery begins. At the set time before each dose, the alarm
sounds,
START
silence the alarm for three minutes. Then reconnect the pump to the patient.
For example, press [
the next scheduled delivery.
When programming the call back alarm, be sure to allow enough time for the
patient or caregiver to reconnect the pump to the patient and to press [
BEFORE the scheduled dose start time.
Press [
• YES/ENTER
d
Press [
• NO
Note: The call back alarm works only when the pump is powered on AND in the
mode. DO NOT power-off the pump while it is disconnected from the patient if you have set
the call back alarm.
10
Confirm the displayed time is correct. Press [
required.
11
The current time and
Press [
• YES/ENTER
Press [
• NO
desired start time and press [
12
Review the program.
WARNING: If the cassette is removed from the pump, ALWAYS disconnect
the pump set from the patient and purge the line before
restarting therapy.
f
Tip: To use a delayed start without specifying a start time: (1) Press [
(2) Complete the program review; (3) Power-off the pump; (4) When the pump is
powered on again, complete the program review, then press [
delivery.
50
flashes on the display, and the alarm LED flashes. Press [
] [ ] to set the alarm to sound 10 minutes before the start of
1 0
] to set the call back alarm.
] if you do not want to set the call back alarm.
displays.
START NOW?
] to begin delivery when the pump enters the
] to set a delayed start time.
YES/ENTER
Abbott GemStar Manual 430-600095-002 (Rev. 8/02)
displays.
] to change the clock if
OPTIONS
RUN
displays. Enter the
SET START TIME
] when done.
START
] to
SILENCE
]
START
STOP
mode.
];
YES/ENTER
] to begin