Clear Transmit Buffer - AEA PAKRATT PK-232 Operating Manual

USER'S GUIDE
EAS
Set ON when operating Morse, Baudot RTTY and AMTOR – these modes don't use
lower case characters. You can operate in a relaxed and normal manner, typing entirely
in lower case if that's easier for you. With
case typing into UPPER CASE Morse or Baudot/CCITT characters.
EAS
When
ters appear on your screen at the time it is sent to the air.
Type EAS OFF
file. The PK-232 responds with:
EAS
Type EAS ON
EAS
3.4.2.11

Clear transmit Buffer (

TCLEAR
Use the
transmission of data.
Type TCLEAR
o You must be in the Command Mode to use
o Use <CTRL-C>
o Type TCLEAR<RETURN>
PK232UG Rev. B 9/86
is ON when operating Morse, Baudot and AMTOR, only UPPER CASE charac-
to see your typing exactly as you type the characters or send from a disk
was ON
to see the data as it appears on the air. The PK-232 responds with:
was OFF
TCLEAR
command to clear your PK-232's transmit buffer and cancel any further
or TC followed by <RETURN>.
(default) command to return to Command Mode.
or TC<RETURN>
EAS
ON, your PK-232 translates your lower
)
TCLEAR
.
to clear the transmit buffer.
3-17
BASIC OPERATION
53