Cmdtime; Cmsg - AEA PAKRATT PK-232 Operating Manual

Multi-mode data controller
Hide thumbs Also See for PAKRATT PK-232:
Table of Contents

Advertisement

USER'S GUIDE
NOTE:
If your PK-232 is being used as the TNC for a PBBS (Packet Bulletin Board System),
change the
the characters frequently found in Packet network maps.
See CHDOUBLE and CHCALL for further information on the use of
n

CMDTIME

Mode: Packet
n
Parameters:
-
CMDTIME
sets the time-out value in Transparent Mode. A guard time of
to Command Mode from Transparent Mode, while permitting any character to be sent as data.
The same Command Mode entry character
Converse Mode is used to exit Transparent Mode, although the procedure is different.
The Command Mode entry characters is set by
Three Command Mode entry characters must be entered less than
tervening characters, after a delay of
You will then see the normal Command Mode prompt:
The following diagram illustrates this timing:
CMSG ON|OFF
Mode: Packet/AMTOR
Parameters:
ON -
OFF - The text message is not sent at all

CMSG

enables or disables automatic transmission of the CTEXT message when your PK-232 ac-
cepts a connect request from another station, or when a distant AMTOR station transmits a
"WRU?" character (FIGS D).
CMSG
Set
ON to tell callers that you're not available to answer calls manually when they con-
nect to your PK-232.
CMSG
Set
OFF when available to operate or answer calls manually.
PK232UG Rev. B 9/86
CHSWITCH
character to $00 to avoid possible conflict or problems with
Mnemonic: CM
0 to 250 specifies timeout value in one-second intervals while in TRANSPA-
RENT Mode
n
If
is 0 (zero), exit from Transparent Mode requires sending the BREAK
signal or interruption of power to the PK-232.
n
Mnemonic: CMS
The recorded CTEXT message is sent as the first packet after a connection is
established by a connect request from a distant station or in response to a
"WRU?" command in AMTOR.
Default: 1
COMMAND
(default <CTRL-C>) is used to exit from the
COMMAND
.
seconds following the last characters typed.
cmd:
Default: OFF
6-28
COMMAND SUMMARY
CHSWITCH
.
n
seconds allows escape
n
seconds apart, with no in-
130

Advertisement

Table of Contents
loading

Table of Contents