8Bitconv; Aab; Abaud - AEA PAKRATT PK-232 Operating Manual

Multi-mode data controller
Hide thumbs Also See for PAKRATT PK-232:
Table of Contents

Advertisement

USER'S GUIDE
8BITCONV ON|OFF
Mode: Packet
Parameters:
ON -
OFF - The high-order bit IS stripped in Converse Mode.

8BITCONV

permits packet transmission of 8-bit data in Converse Mode.
8BITCONV
If
is OFF, the high-order bit (bit seven) of characters received from the terminal is re-
moved before the characters are transmitted in a packet.
The standard ASCII character set requires only seven bits – the eighth or final bit is used as a pa-
rity bit or ignored.
Setting bit seven in text characters transmitted over the air may cause confusion at the other
end.
If you need to transmit eight-bit data but don't want all the features of Transparent Mode, set
8BITCONV
AWLEN
ON and
set.
Because commands require only the standard seven-bit ASCII character set, bit seven is always re-
moved in Command Mode.
AAB text
Mode: Baudot, ASCII, AMTOR
Parameters:
text - Any combination of characters up to a maximum of 17 characters.

AAB

Use the
command to enter an acknowledgment text in the ANSWERBACK section of the PK-
232's memory. AAB sends automatic confirmation in Baudot, ASCII and AMTOR operation in re-
sponse to a distant station's
sages used only in the Packet Mode. Set
Type
AAB {17-character text}
n

ABAUD

Mode: ASCII
Parameters:
n
-
n
The available
ASCII data rates are: 45, 50, 57, 75, 100, 150, 200 and 300 bauds.
ABAUD
Example:
300
ABAUD
sets the radio ("on air") baud rate only in the ASCII operating mode. This value has no re-
lationship to your computer or terminal program's baud rate.
ASCII RTTY operation requires you to use the same rate used by the distant station.
PK232UG Rev. B 9/86
Mnemonic: 8B
The high-order bit IS NOT stripped in Converse Mode.
8. This may be desirable if you're using a special non-ASCII character
Mnemonic: AA
WRU?
command,
WRU?
to store your AnswerBack in memory.
Mnemonic: AB
Specifies the ASCII data rate or signaling speed in bauds from your PK-232
to your radio.
Default: OFF
Default: empty
AAB
is not related to the
ON to activate your answerback.
Default: 110 bauds
6-12
COMMAND SUMMARY
CTEXT
BTEXT
and
mes-
114

Advertisement

Table of Contents
loading

Table of Contents