Table of Contents
Advertisement
USER'S GUIDE
?VIA
You typed more than one call sign for the
VIA keyword.
?not while disconnected
You tried to set
?channel must be 0-9
You typed an invalid channel character after the
?already connected
You tried to
?different connectees
You tried to
6.4.3.
Link Status Messages
Link status messages show you the status of AX.25 connections in which your PK-232
may be involved.
You can ask for link status at any time from the Command Mode by typing the
command without parameters.
If you attempt a connection when your PK-232 is not in the disconnected state, your mon-
itor displays the link status but takes no other action.
The following messages appear in response to the
Link state is: CONNECTED to call1
Your station is connected to a distant station – you'll see the digipeater path in use, if any.
The call sign sequence is the same sequence you would type to initiate the connection.
Link state is: DISCONNECTED
No link or connection exists right now. You may type the
connection.
Link state is: CONNECT in progress
You've already typed a connect request, but the acknowledgment from the other station
has not been received. If you type the
canceled.
PK232UG Rev. B 9/86
CONPERM
while disconnected.
CONNECT
a station to which you're already connected.
CONNECT
to more than one station on the same logical channel.
(VIA call2[,call3...,call9])
CONNECT
UNPROTO
or
CHSWITCH
CONNECT
CONNECT
DISCONNE
command, the connect process will be
6-8
COMMAND SUMMARY
commands without the
character.
CONNECT
command:
command to initiate a
110
Advertisement
Table of Contents
