Table of Contents
Advertisement
USER'S GUIDE
Type
MY AAA
Type
C AAA
play:
Type a few characters, any character, followed by a <RETURN>. After a few moments,
your monitor should echo the same characters that you've just typed.
Type
CONTROL-C
respond with:
Type
VHF OFF
Type
HB 300
Type
K
followed by a <RETURN>. Your monitor should echo the characters you've just
typed.
Type CONTROL-C. Your monitor should respond with:
Type
D
followed by a <RETURN>. Your monitor should respond with:
If you've done all the above steps successfully, you've completed the system quick-check
- you're ready to begin operating.
If you have problems with the steps shown above, return to step 1 AFTER checking all
cables and connectors. Read each step again carefully. If you still have problems, shut
down your PK-232 and contact AEA's Customer Service Department as suggested in the
front of this User's Guide.
2.5
Command List Displays
Type the command word display. Your screen will show:
DISPLAY
A,C,I,L,M,R,T,Z
PK232UG Rev. B 9/86
followed by a
<RETURN>
MYCALL was PK232
followed by a <RETURN>. After a few moments, your monitor should dis-
*** CONNECTED to AAA
(type
C
while pressing the
cmd:
followed by a <RETURN>. Your monitor should respond with:
VHF
was ON
followed by a <RETURN>. Your monitor should respond with:
HBAUD
was 1200
cmd:
*** DISCONNECTED:
(or ENTER key). Your monitor should display:
CONTROL
key down). Your monitor should
(AAA)
2-7
INSTALLATION
25
Advertisement
Table of Contents
