Error Messages - AEA PAKRATT PK-232 Operating Manual

USER'S GUIDE
6.1.3.

Error Messages

If your PK-232 can't understand what you've typed, you'll get an error message in English
reporting the nature of the error.
o If you type a command your PK-232 can't understand – you'll see:
o If you type a correct command with a wrong argument:
o If you type a numerical value outside a parameter's range:
o If you set the BEACON timing too short for busy channels:
o If you type an improper SELCAL:
Here are a few more examples:
ASDFASDF
cmd:
?What?
BEACON E
cmd:
?bad
PACLEN 265
cmd:
?range
DAY
cmd:
?clock not set
x
cmd:
C N6IA
cmd:
?not while in PACKET
C N6IA
cmd:
?not while in MORSE
C N6IA
cmd:
?not while in ASCII
C N6IA
cmd:
?not while in BAUDOT
PK232UG Rev. B 9/86
?What?
?bad
?range
WARNING: BEACON too often
?call sign
– This isn't a command
– A parameter was left out
– Unacceptable numerical value
– You didn't set the PK-232's clock
– Command is invalid for the mode in use
– Command is invalid for the mode in use
– Command is invalid for the mode in use
– Command is invalid for the mode in use
– Command is invalid for the mode in use
6-2
COMMAND SUMMARY
104