Table of Contents
Advertisement
Site Requirements
Refer to and follow all local, state and federal electrical and plumbing code requirements in your area.
WARNING:
The System 83 Plus™ must not be located next to or near an X-Ray, CAT scan or MRI equipment.
WARNING:
The System 83 Plus™ equipment is not suitable for use in the presence of flammable mixtures with air
or with oxygen or nitrous oxide.
Electrical Requirements
The System 83 Plus™ requires one dedicated 120 VAC (±10%), 20 AMP, 60 Hz, Single Phase, NEMA 5-15R
receptacle located within the operator's reach.
CAUTION:
GFCI receptacle(s) are not recommended since the System 83 Plus™ contains an electrostatic
isolation transformer that reduces leakage to ground and may trip the hospital breaker, the System 83
Plus'™ breaker or both.
CAUTION:
Do not connect or operate System 83 Plus™ using an emergency generator outlet because it may
create current surges that may damage computer components.
Water Requirements
•
The potable tap water plumbing supply line(s) to be provided by the facility for the System 83 Plus™ must
be ½" or ¾" supply line(s) with a reduced pressure backflow preventer and shut off valves terminating in ¾"
male garden hose connections
Water pressure between 55 and 70 psi (pounds per square inch)
•
Maximum flow rate of 6.0 gpm (gallons per minute)
•
•
Water temperature of 110°F (±5°F)
•
Water hardness less than 12 gpg (grains per gallon) or 200 ppm (parts per million)
NOTE:
It is recommended that the facility water be analyzed to determine if the facility water is potable.
Reverse osmosis and deionized water should not be used in the System 83 Plus™.
Waste Drain Requirements
The System 83 Plus™ requires a minimum 2" in diameter vented standpipe with a height of 18" above floor level that
is capable of draining a minimum of 4.5 gpm (gallons per minute) per bay is required for the System 83 Plus™.
MAN–202
System 83 Plus™ Washer/Disinfector
Revision 03082022
Service Manual
Page 13 of 54
Advertisement
Table of Contents
Need help?
Do you have a question about the 83 Plus System 2 and is the answer not in the manual?