Mahindra XUV700 2021 Diagnostic Manual page 92

Diagnostic Manual
XUV700 (Diesel)
• Battery voltage is 12V
• Go to step 3
STEP 3 – CHECK THE BATTERY VOLTAGE AT EMS ECU
PRE CONDITION
• Ignition OFF
• Remove the EMS ECU connector C 532K
• Ignition ON
TEST PROCEDURE
• Check the battery voltage at pin number 1 of C 532K
• Check the battery voltage at pin number 3 of C 532K
• Check the battery voltage at pin number 5 of C 532K
ACCEPTANCE CRITERIA
• Is the battery voltage is 12V
• Go to step 4
STEP 4 – CHECK THE EMS ECU MAIN RELAY CONTROL SIDE LINE
PRE CONDITION
• Ignition OFF
• EMS ECU main relay
• Remove the EMS ECU connector C 532K
TEST PROCEDURE
• Check for resistance between pin 161 of C 144 (EMS ECU main relay) and pin number 19
of C 532K
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document, are
92
prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd., will
amount to unauthorized use and shall be liable for penalty/prosecution© 2021 Mahindra & Mahindra Ltd.
ACTION TO BE TAKEN
OK
ACTION TO BE TAKEN
OK
UICU
NOT OK
• Check the wiring harness for any open or
short circuit and replace or repair the wiring
harness
NOT OK
• Check the wiring harness for any open or
short circuit and replace or repair the wiring
harness
MAN-01065
OCT - 2021/Rev 1