Mahindra XUV700 2021 Diagnostic Manual page 93

Diagnostic Manual
XUV700 (Diesel)
ACCEPTANCE CRITERIA
• Is the resistance value is <1Ω
• Go to step 5
STEP 5 – CHECK THE EMS ECU GROUND WIRES
PRE CONDITION
• Ignition OFF
• Remove the EMS ECU connector C 532
• Remove the G 5 ground terminal
TEST PROCEDURE
• Check the resistance between pin number 4 of C 532K and G 5
• Check the resistance between pin number 6 of C 532K and G 5
• Check the resistance between pin number 2 of C 532K and G 5
ACCEPTANCE CRITERIA
• Is the resistance value is <1Ω
• Go to step 6
STEP 6 – CHECK THE EMS ECU SUPPLY WIRES
PRE CONDITION
• Ignition OFF
• Remove the EMS ECU main relay
• Remove the EMS ECU connector C 532K
• Remove the Ignition Switch connector C 102
TEST PROCEDURE
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by
the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2021 Mahindra & Mahindra Ltd.
ACTION TO BE TAKEN
OK
ACTION TO BE TAKEN
OK
UICU
NOT OK
• Check the wiring harness for any open or
short circuit and replace or repair the wiring
harness
NOT OK
• Check the wiring harness for any open or
short circuit and replace or repair the wiring
harness
MAN-01065
OCT - 2021/Rev 1
93